Others

Job Timeout (jobwtimeout)

Specify the time-out period to wait for the job to end in seconds.

This setting is valid for the following jobs:

• Pre-send Job

• Successful Job when 'Successful Job Completion' is specified for Receive Management Information Notification (JOBWAIT)

• Job that starts after detection of file creation, deletion, or modification with the File Trigger function

HULFT enables the set value of this field when you specify the synchronous execution request in the Remote Job Execution command (utlrjob) without setting the Synchronous Transfer Timeout.

Regarding other job execution, HULFT waits for the termination of a job without limitation.

Refer to Settings for timeouts for details.

Transfer Status Transfer Count (disptranscnt)

Specify the number of transfer data counts acquired at one time when the transfer status is displayed.

Observe Log Output

Specify whether the Observe Log is output or not for each service to be acknowledged.

The service names that you can specify are as follows:

SEND:

Send Request

RESEND:

Resend Request

HULADMIN:

Connection request from HULFT Manager

HULSNDRC:

Job Execution Result Notification

HULJOB:

Job Monitor Request

HULRJOB:

Remote Job Execution

TRGCONF:

File Trigger Information Control

Note

You can specify "TRGCONF" if HULFT10 Server grade is installed.

= Remarks =

Refer to Observe definition settings for details about the Observe Definition file.

Status Display Selection (statusdisplay)

Specify the type of transfer status to be displayed in the Transfer Status List screen of the HULFT Management Console.

0:

Display only the send status

1:

Display the send status and the receive status

HULFT Script Port No. (hsport)

You can use this field when DataSpider Servista is installed.