Send processing (SAN) messages

HULFT-SAN is installed. (ML=I)

The Send processing started in HULFT-SAN. (ML=I)

The data is sent via LAN, because conditions for sending via HULFT-SAN were not met. (ML=W)

The partition for the data transfer volume is currently being used. Retry will be executed the specified number of times. (ML=W)

Failed to access the volume for data transfer of XL data mover. (ML=E)

Refer to the XL data mover handbook with the recovery code or detail code, and take the appropriate measures.

HULFT-SAN is not installed on the host on the receiving side. (ML=W)

An error has occurred during the attempt to open the volume for data transfer. (ML=E)

Refer to the XL data mover handbook with the detail code, and take the appropriate measures.

The Receive processing was not executed, because the host on the receiving side did not meet the conditions for the Receive processing in HULFT-SAN. (ML=E)

Check if the conditions for SAN transfer are met.

The Send processing started in HULFT-SAN. (ML=I)

The data is sent via LAN, because conditions for sending via HULFT-SAN were not met. (ML=W)

The Send processing was not executed, because the conditions for the Send processing in HULFT-SAN were not met. (ML=E)

Check if the conditions for SAN transfer are met.

HULFT-SAN is not installed on the host on the receiving side. (ML=W)

Transfer will be executed via proxy. (ML=W)

The host on the receiving side is a Mainframe. (ML=W)

The Send file is not a Sequential Organization file. (ML=W)

The Send processing is carried out for a file on a tape volume. (ML=W)

The Work File Transfer is set. (ML=W)

Code conversion is set on the host on the sending side. (ML=W)

The Send file does not exist on the shared volume. (ML=W)

The environment or conditions are not appropriate for SAN transfer. (ML=W)

Check if the conditions for SAN transfer are met on the host on the sending side and the host on the receiving side.

The Send file is a multi-volume file. (ML=W)