Status codes and detail codes for Observe processing

Ended successfully.

The Send Request sent in the Synchronization Mode failed.

The File ID for the request is not registered.

The Transfer Group ID for the request is not registered.

The applicable host is not registered in the Transfer Group ID for the request.

The Format ID of the File ID for the request is not registered.

Failed to create the Send work file.

For details, refer to the console message.

Failed to obtain exclusive control of the Send Control file (HULFT.QUEUE).

This may be due to a problem in the environment settings of your operating system.

Failed to register the Send Control file (HULFT.QUEUE).

For details, refer to the console message.

For detail codes, refer to Error code list.

Failed to acquire the Send file in order to clear the Send file. Check if it is in use by another job.

Failed to clear the Send file. An I/O error may have occurred in the Send file.

The Multi Format ID that is specified for multi format transfer does not exist.

The Format ID that is specified for the Multi Format ID does not exist.

If any of the following conditions are met, multicasting is not possible.

• Send mode is other than Keep for the Direct Transfer.

• Send mode is Lock for the Work File Transfer.

• Send mode is Clear or Delete for the Work File Transfer, and the Post-send Clear Mode in the System Environment Settings is 'A.'

An error occurred during access of the Host Information file (HULFT.HOST).

Processing for replacement with message failed.

Failed to delete the Send file. An I/O error may have occurred in the Send file.

Failed to acquire the UNIT name for the Send file.

The Send file on a tape volume cannot be cleared or deleted.

Failed to acquire the attributes of the Send file.

Registration in the Send Control file (HULFT.QUEUE) failed.

The data set for the Send file is not supported.

The record format of the Send file is not supported.

The record length of the Send file is invalid.

The block length of the Send file is invalid.

You cannot clear Partitioned Organization files or VSAM Organization files.

You cannot delete Partitioned Organization files or VSAM Organization files.

The member name of the Partitioned Organization file is invalid.

The APF-authorized function is not enabled.

The Send Request ended in time-out.

The Send file attributes are invalid for Sending with RDW.

A user table cannot be specified for code conversion to UTF-8.

The record length exceeded 32750 bytes after code conversion to UTF-8.

The Send processing was canceled during the Synchronous Transfer.

An error occurred during job execution.

The job ID does not exist.

A time-out occurred during job execution.

Canceled the request.

Failed to communicate in Forced Strong Key mode.

Check the settings, and then try the connection again.

An error occurred in the z/OS Unicode Services during code conversion.

This is a HULFT system error. "XRC0010" is displayed on the console.

If you have a technical support agreement, check the return code and the reason code displayed in the error message and then contact your Technical Support Service representative.

Use of plus signs is not supported in relative generation numbers for generation files.

The connection was disconnected due to a network error.

No Host Information when the service was accepted

No execution permission when the service was accepted

A request that is not supported was accepted. This error occurs if sending is started for the Observe program.

Check if the Receive port number and the Observe port number are set correctly on the remote host.

Ended successfully.

No records for the applicable host exist in the Resend Queue.