Send File (a file transfer started on the sending side)

The Send File command is used to start a file transfer from the side that holds the file to be transferred.

You can execute the Send File both on the HULFT Management Console and by using a batch command.

This section describes the method to execute the Send File from the Issue Request menu on the HULFT Management Console.

(1) Display of the Send File dialog box

On the HULFT Management Console, click Issue Request > Send File > Send File. The Send File dialog box appears.

(2) Execution of the Send process

In the Send File dialog box, enter the file ID for which you issue the Send File command, and click Send File.

When the Send File has been successfully ended, the message 'Request issue operation successful' is displayed.

(3) Confirmation from the Console Logs screen

The Console Logs screen displays messages that indicate the start and end of the Send processing.

The processing of the Send File that was issued from the HULFT Management Console is now complete.

= Remarks =

If an error occurs, take the following actions:

  • Verify the Host Information settings.

  • Verify whether the host names in the Host Information have been registered correctly or not (pay attention to case sensitivity).

  • Refer to Error Codes and Messages for the error code shown in the message box indicating the issue request failure.

  • Refer to Error Codes and Messages for the respective error codes and error messages, if an error message is displayed in the Console Logs screen.