Other Settings

Use the up arrow key and the down arrow key to move the cursor to 9. Other Settings on the System Environment Settings screen and then press the Enter key.

 

The Other Settings screen appears.

 

On this screen, specify the following field:

(1) HULFT Script Port No.

If you perform a New Installation with a product key that includes HULFT Script and one of the following products is used, set HULFT Script Port No. (hsport) to the appropriate port number in the System Environment Settings.

  • HULFT8 Script Option for UNIX

  • HULFT8 Script Option for Linux

  • HULFT8 Script Option for zLinux

  • DataSpider Servista

If neither of the above is installed and a port number is set for HULFT Script Port No. (hsport) in the System Environment Settings, a warning message is output in the trace log for every transfer.

In this case, delete the value of HULFT Script Port No. (hsport) in the System Environment Settings using the HULFT Management Console.

 

Even if you add HULFT Script Option by updating the product key, the value of HULFT Script Port No. (hsport) is not automatically changed in the System Environment Settings. When you add HULFT Script Option, set HULFT Script Port No. (hsport) to the appropriate port number in the System Environment Settings.

For details, refer to Steps to take before using HULFT Script.

                                                                                
                              <<Other Settings>>            ESC: Cancel
                                                            TAB: Select
                                                          Ctr+s: Switch Screen
 Utility Timeout              : 60
 Job Timeout                  : 999999
 Log Switchover Record Count  : 0
 Status Display Selection     : 1 (0:1)
 HULFT Identifier             :
 HULFT Script Port No.        :





 ------------------------------------------------------------------------------
 This field specifies the timeout for a response in seconds in the case where
 following utilities issue a request to a daemon of HULFT:
 utlsend        utlrecv           utlscan          utlschange
 utlkillsnd     utlalivecheck     utltriggerconf
 You can specify from 10 to 259200 as a timeout for a response in seconds.
 999999: Wait indefinitely.
 Default value is 60.

Screen 4.8 Other Settings Screen

After specifying the required field, press the Enter key.

 

The setting is saved and the System Environment Settings screen appears.