Others

Job Timeout (jobwtimeout)

Specify the time-out period to wait for the job to end in seconds.

This setting is valid for the following jobs:

• Pre-send Job

• Successful Job when 'Successful Job Completion' is specified for Receive Management Information Notification (JOBWAIT)

• Job that starts after detection of file creation, deletion, or modification with the File Trigger function

HULFT enables the set value of this field when you specify the synchronous execution request in the Remote Job Execution command (utlrjob) without setting the Synchronous Transfer Timeout.

For other job executions, HULFT waits indefinitely for the end of the job.

For details, refer to Windows Administration Manual.

HULFT-SAN Ver.5 Product (san_ver5)

You can use this field if HULFT-SAN for Windows is installed. For details, refer to HULFT-SAN Manual.

Transfer Status Transfer Count (disptranscnt)

Specify the number of transfer data counts acquired at one time when the transfer status is displayed.

Observe Log Output

Specify whether the Observe Log is output or not for each service to be acknowledged.

The service names that you can specify are as follows:

SEND:

Send Request

RESEND:

Resend Request

HULADMIN:

Connection request from HULFT Manager

HULSNDRC:

Job status notification request

HULJOB:

Job Monitor Request

HULRJOB:

Remote Job Execution

TRGCONF:

File Trigger Information Control

Note

You can specify 'TRGCONF' if HULFT8 Server grade is installed.

= Remarks =

Refer to Windows Administration Manual for details about the Observe Definition file.

Status Display Selection (statusdisplay)

Specify the type of transfer status to be displayed in the Transfer Status List screen of the HULFT Manager Management Console.

Display Only Send:

Display only the send status

Display All:

Display the send status and the receive status

HULFT Script Port No. (hsport)

You can use this field when HULFT Script is installed. For details, refer to HULFT Script Manual for the destination host.