Startup of the setup program

In new installation, use the setup program that is restored in Restoration of objects.

By using the following command, run the setup program:

Setup command

CALL PGM(QTEMP/SETUP) [PARM('LANG={JPN|ENG}')]

Explanation of parameters

LANG={JPN|ENG}

Display language option for setup program

JPN:: Japanese
ENG:: English

If omitted, the setup program selects the display language assuming from the system value of the QLANGID (Language identifier).

JPN:: Japanese
Value other than JPN:: English

When the setup program starts, the Entry of License Information screen appears.

For details on the Entry of License Information screen, refer to Entry of license information.

= Remarks =

On any screen of the setup program, you can go back to the previous screen by pressing F12 key. In addition, you can cancel the installation by pressing F3 key.

Note

If you cancel the installation process by pressing F3 key and the like while the setup program is running, redo the procedure in Startup of the setup program from the beginning.
If an error occurs in the setup program, a library might remain unrestored. To redo the installation, make sure that no unnecessary library exists. If it does, delete it.