Receive Management Information

To upload objects to object storage, set the Receive Management Information as follows:

File Name (FILENAME)

When uploading receive files to the object storage, specify a path in the following format for File Name of the Receive Management Information according to the object storage that is the upload destination.

Table 5.5 Path to specify for File Name in the Receive Management Information

Type of Object Storage

Path to specify for File Name in the Receive Management Information

HULFT Cloud Storage Option
Ver.8.5.0 or lower

HULFT Cloud Storage Option
Ver.8.5.1 or higher

Amazon S3

s3://bucketname/objectname

s3://bucketname/objectname
or
s3://ReceiveStorageManagementInformationID/objectname

Azure Blob Storage

bs://containername/objectname

bs://containername/objectname
or
bs://ReceiveStorageManagementInformationID/objectname

Google Cloud Storage

gs://bucketname/objectname

gs://bucketname/objectname
or
gs://ReceiveStorageManagementInformationID/objectname

For details on the Receive Storage Management Information ID, refer to Receive Storage Management Information settings.

Note

  • The prefixes "s3://," "bs://," and "gs://" are fixed strings corresponding to each type of object storage. Be sure to specify lowercase characters only.

  • Use "/" when specifying the path.

  • The file name is used as the bucket name, container name, and object name in the object storage.

    You cannot specify multibyte characters for the bucket name or container name due to object storage specifications.

If the version of HULFT Cloud Storage Option is Ver.8.5.0 or higher, Receive File Name in the Receive Management Information can be changed dynamically.

Table 5.6 Example of acquisition with dynamic specification

Send File Name

Receive File Name (Linux)

$SNDPATH$SNDFILE

$SNDFILE

s3://bucket2/$SNDFILE

s3://bucket/hulft

/hulft

hulft

s3://bucket2/hulft

s3://bucket/hulft/cloud

/hulft/cloud

cloud

s3://bucket2/cloud

s3://bucket/hulft/cloud/op

/hulft/cloud/op

op

s3://bucket2/op

If $SNDPATH$SNDFILE is specified for Receive File Name, the folder name starts with a "/" as shown above. Therefore, it becomes a HULFT transfer.

You cannot specify any strings before $SNDPATH. Therefore, when using the send file name to upload files to object storage, specify strings with $SNDFILE after the prefix.

Registration Mode (TRANSMODE)

Specify "N" (New Creation) or "R" (Replace).

Error Handling (ABNORMAL)

Specify "R" (Restore).

Receive Mode (RCVTYPE)

Specify "S" (Single).

Generational Management (GENCTL)

Specify "N" (Generational management is disabled).

 

For items other than the above, check HULFT functional restrictions for uploads to object storage, and then set them according to actual operations.