Detail codes when errors occur on sending-side hosts

Confirm that the combination of the code set specified for the Code Set for Transfer (KCODETYPE) in the Host Information and the setting of the EBCDIC Set in the Send Management Information or the Receive Management Information is supported.

For details, refer to the explanation on Convertible Code Set Combinations in Code Conversion Manual.

Failed to communicate in Forced Strong Key mode.

Confirm that the communication destination meets all of the following conditions:

1. The Forced Strong Key mode is enabled.

2. The version of HULFT is V8.4.0 or higher.

3. HULFT Cipher Option (AES) Ver.8.0.0 or higher is installed.

The Forced Strong Key mode in the System Environment Settings and the length of the cipher key in the management information do not match.

1. If the Forced Strong Key mode is enabled, specify a hexadecimal character string of 64 bytes for the cipher key.

2. If the Forced Strong Key mode is disabled, specify an alphanumeric character string of 0 bytes or an alphanumeric character string of 8 to 20 bytes for the cipher key.

3. An Instant transfer cannot be performed when the forced mode is enabled.

This is a Send file access error.

Failed to allocate the memory for the buffer for the Send processing.

Cancelation processing was carried out on the host on the sending side.

This is a version error.

Failed to carry out the Direct Transfer.

Cannot carry out the Checkpoint Resend File.

This is a SAN transfer error.

An error has occurred during the attempt to open the shared volume.

An error has occurred during the attempt to output to the shared volume.

Failed to convert between EBCDIC codes.

An error has occurred during pack zone conversion.

An error has occurred during encryption processing.

A user table cannot be specified for code conversion to UTF-8.