Detail codes when errors occur on receiving-side hosts

This is a Receive file access error.

Failed to allocate the memory for the buffer for the Receive processing.

The version of HULFT on the host on the sending side does not match.

A protocol error has occurred on HULFT.

Failed to output the Receive file.

Failed to allocate the Receive file.

Failed to release the Receive file.

Failed to open the Receive file.

Failed to close the Receive file.

The specified File ID is not registered in the Receive Management Information.

The applicable file ID is in use by the Receive processing.

Cancelation processing was carried out on the host on the receiving side.

The Receive file already exists.

The Post-receive Job failed.

A time-out occurred during Post-receive Job execution.

The number of connections exceeded the specified Receive Multiplex Level on the host on the receiving side.

The host on the sending side does not support the Transfer Test function.

The contents of the Receive Management Information are inappropriate.

This is a Transfer Group host name error.

An error occurred during dynamic change of the Send file name.

Failed to convert between EBCDIC codes.

This is a record count error or a record size error.

This is a custom character conversion error.

An error occurred during decryption of the encrypted data.

An error occurred during dynamic replacement with message.

The volume serial number for the Receive file is unknown.

An error has occurred during data verification.

An error has occurred during data verification (a version inconsistency).

A user table cannot be specified for code conversion from UTF-8.

Code conversion from UTF-8 is not possible.

XML transfer is specified on the host on the sending side.

A request that is not supported was accepted. This occurs when a request such as the Send Request is issued to the Receive program (XRRCV).

Confirm that the combination of the code set of the remote host that is specified for the Code Set for Transfer (KCODETYPE) in the Host Information and the code set that is specified for the Code Set for Transfer (CS4TRNSFR) in the System Environment Settings is supported.

For details, refer to the explanation on Convertible Code Set Combinations in Code Conversion Manual.

Confirm that the combination of the code set specified for the Code Set for Transfer (KCODETYPE) in the Host Information and the setting of the EBCDIC Set in the Send Management Information or the Receive Management Information is supported.

For details, refer to the explanation on Convertible Code Set Combinations in Code Conversion Manual.

Failed to communicate in Forced Strong Key mode.

Confirm that the communication destination meets all of the following conditions:

1. The Forced Strong Key mode is enabled.

2. The version of HULFT is V8.4.0 or higher.

3. HULFT Cipher Option (AES) Ver.8.0.0 or higher is installed.

The Forced Strong Key mode in the System Environment Settings and the length of the cipher key in the management information do not match.

1. If the Forced Strong Key mode is enabled, specify a hexadecimal character string of 64 bytes for the cipher key.

2. If the Forced Strong Key mode is disabled, specify an alphanumeric character string of 0 bytes or an alphanumeric character string of 8 to 20 bytes for the cipher key.

3. An Instant transfer cannot be performed when the forced mode is enabled.

Multi is specified for the Multivolume.

The Receive file has been specified as a generation file.

Append is specified for the Registration Mode.

Multiple Receive is specified for the Receive Mode.

The Print Character is specified.

The type of the unit that is specified for the UNIT is tape media (MT).

The Class is specified in the Receive Management Information.

An error has occurred during the attempt to open the shared volume.