When you start the Observe process, the startup message is not output to the trace log

Phenomenon

When you start the Observe process, the startup message below is not output to the trace log.

Message 1

I2009005   MSG=hulobsd start (from hulclusterobs -endwait).

Message 2

I2009006   MSG=hulobsd start (from hulclusterobs).

Message 3

I2009007   MSG=hulobsd start.

Severity level

C: medium

Affected versions

From Ver.10.2.0 to Ver.10.2.0A

Modified version

Ver.10.2.1

Condition to reproduce

This phenomenon occurs when one of the following conditions is met:

In the case of Message 1 listed under "Phenomenon"

The phenomenon occurs when you execute the Observe daemon start synchronization command (hulclusterobs -start -endwait) in Heartbeat mode.
In the case of Message 2 listed under "Phenomenon"

The phenomenon occurs when you execute the Observe daemon start synchronization command (hulclusterobs -start) in Synchronization mode.
In the case of Message 3 listed under "Phenomenon"

The phenomenon occurs when you execute the Observe system startup command (hulobsd).

Alternative workaround

None

Status description

Even if the above conditions are met, the message is output to the trace log.