File Trigger Information Control command

By running the File Trigger Information Control command, you can dynamically reload the File Trigger information without restarting the Observe process. In this case, if a job is being executed, the command to control interval for reading File Trigger Information waits until the job ends. When the command to control interval for reading File Trigger Information is being executed, if the command is run again, the Observe process returns an error that indicates that the command is being executed. The service name is TRGCONF.

Format of command

utltriggerconf -r [-sync [-w time]]

Explanation of the parameters

-r

File trigger information reload request (Mandatory)

-sync

Synchronous read request (Optional)

If you omit this parameter, HULFT executes the request asynchronously.

-w time

Synchronous timeout (seconds) (Optional)

The time for the synchronization to receive the processing results at the time of Synchronous Transfer is specified in the range of '10' to '259200.'

When you omit this parameter, the value that is set for Utility Timeout (utlwait) in the System Environment Settings file (hulenv.conf) is applied.

To specify this parameter, you must specify the parameter "-sync".