Start synchronization commands
To start a HULFT daemon in a clustering environment, execute the corresponding one of the following daemon start synchronization commands. The following commands use the same parameters.
Send Daemon Start Synchronization Command
hulclustersnd -start [-m] [-endwait] [-o hulsndd option]
Receive Daemon Start Synchronization Command
hulclusterrcv -start [-m] [-endwait] [-o hulrcvd option]
Observe Daemon Start Synchronization Command
hulclusterobs -start [-m] [-endwait] [-o hulobsd option]
Parameter explanation
- -m
-
Display of messages (optional)
The command outputs messages.
If you omit this parameter, the command outputs only the message of the argument check error.
- -endwait
-
Heartbeat mode (optional)
The daemon is monitored from the time it is successfully started until it is terminated.
If you omit this parameter, the command starts the relevant daemon in Start Synchronization mode.
- -o hulft-daemon option
-
Specification of optional parameters when a daemon starts (optional)
This parameter specifies the parameters that are used when a daemon starts.
Specify this parameter at the end of the command.
You can specify the following optional parameters (hulft-daemon option) when a daemon starts.
hulsndd option [-d] [-c] [-l [list] |-s] [--noautoretry] hulrcvd option [-l [list] |-s] hulobsd option [-l list]
Remarks
For details on the startup method of the HULFT systems, refer to the following:
HULFT10 for Linux/AIX Operation Manual :