Terminating a HULFT subsystem

To terminate a HULFT subsystem, type the following command and press the Enter key.

Command syntax

ENDSBS SBS(Subsystem Description) OPTION(*CNTRLD) [DELAY(Seconds)]

Note

End the Send Acknowledge job, the Receive Acknowledge job, the Observe job, and the Operation Log Acknowledge job before you end HULFT subsystem.

= Remarks =

  • Specify the subsystem description that you want to end for the Subsystem Description. If you have already renamed the subsystem in accordance with the procedures to create subsystem description that is explained in Installation Manual, specify the renamed subsystem.

  • If you specify the DELAY option, set the maximum end delay time for Seconds.