Overview of log information error code
There are two types of error codes in log information, namely, the Status code and the Detail code. You can check the error codes on the Management screen (UTLADMIN) or by using a list display command (UTLLIST or UTLOBSLIST). Each code is expressed in four digits, so find the last three digits of the Status code.
0000-0000 (Status Code - Detail Code)
The Status code and the Detail code are classified according to the types of the processing where an error occurred.
When the processing completed successfully, the Status code is set to "0".
|
Status Code |
Description |
Reference |
|---|---|---|
|
700 to 756 |
Status Code of Send Program |
|
|
616, 800 to 879 |
Status Code of Receive Program |
|
|
512 to 615 |
Common Status Codes for Send Program and Receive Program |
|
|
1 to 88, 538, 539, 880 to 882 |
Status codes for observe program |
|
|
204, 205, 545, 546, 890 to 894 |
Other Status Codes (common to each program) |
|
|
901 to 903 |
Status Codes related to Operation Log (common to each program) |
|
|
100 to 203 |
Status Codes related to system (common to each program) |
The contents of the Detail code are as follows:
In case of the status code is an error by remote host
In case remote host is zOS, MSP, or XSP
Refer to the explanation on the Detail code upon error at send side or receive side in Error Codes and Messages of the remote host type.
Other than the above
Refer to the Status code in Error Codes and Messages of the remote host type.
Other than the above
The error code (C language) output from the operating system.