Transfer Test Settings

Transfer Preference (TTMODE)

This field specifies whether HULFT operates in Test-priority Mode or in Test-run Mode. (Optional)

0 :

Test-priority Mode

1 :

Test-run Mode

If omitted, "0" is set.

Result Handing of Receiving (TTRCVOMIT)

Specify this field when you use the Transfer Test function. (Optional)

When the local host is a sending host and the value that is specified for the Transfer Preference (TTMODE) is '1' (Test-run Mode), you cannot check transfer operation on a receiving host if either of the following situations is true:

• On a receiving host, the Use HULFT7 Comm. Mode (HUL7MODE) of the Host Information is set to 'Y' (Yes).

• HULFT on a receiving host is lower than HULFT8.

This field specifies whether above situations are treated as an unsuccessful termination or a successful termination.

0 :

Always terminate transfer with error

1 :

Give success when no problem detected on sending host

If omitted, "0" is set.

Output Receive File (TTRCVFILOUTPUT)

Specify this field when you use the Transfer Test function. (Optional)

This field specifies whether to output the Receive file when HULFT carries out file transfer in test operation.

0 :

Do not output the Receive file

1 :

Output the Receive file

If omitted, "0" is set.

Execute Pre-send Job (TTPRESNDJOB)

Specify this field when you use the Transfer Test function. (Optional)

This field specifies whether to execute the Pre-send Job when HULFT carries out file transfer in test operation.

0 :

Do not execute the Pre-send Job

1 :

Execute the Pre-send Job

If omitted, "0" is set.

Execute Post-send Job (TTSNDJOB)

Specify this field when you use the Transfer Test function. (Optional)

This field specifies whether to execute the Post-send Jobs when HULFT carries out file transfer in test operation.

0 :

Do not execute the Post-send Job

1 :

Execute the Post-send Job

If omitted, "0" is set.

Execute Post-receive Job (TTRCVJOB)

Specify this field when you use the Transfer Test function. (Optional)

This field specifies whether to execute the Post-receive Job when HULFT carries out file transfer in test operation.

0 :

Do not execute the Post-receive Job

1 :

Execute the Post-receive Job

If omitted, "0" is set.

Output Results to Transfer Logs (TTSNDRCVLOG)

Specify this field when you use the Transfer Test function. (Optional)

This field specifies whether to output log records to the Send Log and the Receive Log when HULFT carries out file transfer in test operation.

0 :

Do not output log records to the Send Log and the Receive Log

1 :

Output log records to the Send log and the Receive log

If omitted, '1' is set.