Options for Route Settings

In HULFT-HUB, the route settings that you can specify vary depending on HULFT products that are installed on the clients that are at the starting and ending points of the transfer, and on whether the clients are Clients under Control or not.

This topic shows the Route Settings that you can specify for transfers between clients.

[Note]
-	You cannot specify multiple options for Route Settings when multicasting.
-	For transfers that start from a server or end at a server, the Route Settings option that you can specify is 'Auto Arrangement' or 'Manual Arrangement.'
-	If the server is HULFT-HUB Server-L, you cannot configure the Route Settings via servers.

[Remarks]

Registering a client to HULFT-HUB does not affect existing Transfer definitions on the added client. The transfers are carried out in the same way as before the registration regardless of the transfer destinations and transfer types.

 

 <Table> Route Settings That Can Be Specified for Transfers

Sending Client	Receiving Client
	Client under Control	Client outside of Control (with Relay)	Client outside of Control (without Relay)
Client under Control	Via HUB - Auto Arrangement *1 Via HUB - Manual Arrangement Direct Transfer - LAN Transfer		Direct Transfer - LAN Transfer
Client outside of Control (with Relay)			-
Client outside of Control (without Relay)	Direct Transfer - LAN Transfer	-	-

*1:	If there are multiple clients on the receiving side, select 'Via HUB - Auto Arrangement - HUB Multicasting' or 'Via HUB - Auto Arrangement - HULFT Multicasting via HUB.'

[Note]
-	You can specify only 'Auto Arrangement' for the Route Settings of a transfer that involves a host group.
-	For transfers between a client outside of control (without Relay) and a controlled client on the same server, you can define only the Direct Transfer.
-	For multicasting that involves a client outside of control (without Relay), you can specify only the Direct Transfer.
-	When the client on the sending side is a client outside of control (with Relay), in order to modify the Route Settings, you must delete the client on the sending side, and then reinsert the sending client.